diff options
| author | Piotr Dymacz <pepe2k@gmail.com> | 2017-07-02 18:32:38 +0200 |
|---|---|---|
| committer | Piotr Dymacz <pepe2k@gmail.com> | 2017-07-04 08:58:54 +0200 |
| commit | 6165e4aab0e22b780b6b1dde887ed803a7c8210a (patch) | |
| tree | 4f95e80fcccc02122231d83e6f1579f8a97490af /target/linux/ar71xx/base-files/etc/hotplug.d | |
| parent | 0a2e4204dbe0b7bf31cb4100491a01b2837d7f3f (diff) | |
| download | mtk-20170518-6165e4aab0e22b780b6b1dde887ed803a7c8210a.zip mtk-20170518-6165e4aab0e22b780b6b1dde887ed803a7c8210a.tar.gz mtk-20170518-6165e4aab0e22b780b6b1dde887ed803a7c8210a.tar.bz2 | |
ar71xx: add support for TP-Link TL-WR902AC v1
TP-Link TL-WR902AC v1 is a pocket-size, dual-band (AC750), successor of
TL-MR3020 (both devices use very similar enclosure, in same size). New
device is based on Qualcomm QCA9531 v2 + QCA9887. FCC ID: TE7WR902AC.
Specification:
- 650/391/216 MHz (CPU/DDR/AHB)
- 1x 10/100 Mbps Ethernet
- 1x USB 2.0 (GPIO-controlled power)
- 64 MB of RAM (DDR2)
- 8 MB of FLASH
- 2T2R 2.4 GHz (QCA9531)
- 1T1R 5 GHz (QCA9887)
- 5x LED (GPIO-controlled), 2x button, 1x 3-pos switch
- UART pads on PCB (TP1 -> TX, TP2 -> RX, TP3 -> GND, TP4 -> 3V3, jumper
resitors are missing on TX/RX lines)
- 1x micro USB (for power only)
Flash instructions:
Use "factory" image under vendor GUI.
Recovery instructions:
This device contains tftp recovery mode inside U-Boot. You can use it to
flash LEDE (use "factory" image) or vendor firmware.
1. Configure PC with static IP 192.168.0.66/24 and tftp server.
2. Rename "lede-ar71xx-generic-tl-wr902ac-v1-squashfs-factory.bin"
to "wr902acv1_un_tp_recovery.bin" and place it in tftp server dir.
3. Connect PC with LAN port, press the reset button, power up the router
and keep button pressed until WPS LED lights up.
4. Router will download file from server, write it to flash and reboot.
Root access over serial line in vendor firmware: root/sohoadmin.
Signed-off-by: Piotr Dymacz <pepe2k@gmail.com>
Diffstat (limited to 'target/linux/ar71xx/base-files/etc/hotplug.d')
| -rw-r--r-- | target/linux/ar71xx/base-files/etc/hotplug.d/firmware/11-ath10k-caldata | 3 |
1 files changed, 2 insertions, 1 deletions
diff --git a/target/linux/ar71xx/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ar71xx/base-files/etc/hotplug.d/firmware/11-ath10k-caldata index ecbc9b8..a2e98f4 100644 --- a/target/linux/ar71xx/base-files/etc/hotplug.d/firmware/11-ath10k-caldata +++ b/target/linux/ar71xx/base-files/etc/hotplug.d/firmware/11-ath10k-caldata @@ -98,7 +98,8 @@ case "$FIRMWARE" in rb-952ui-5ac2nd) ath10kcal_from_file "/sys/firmware/routerboot/ext_wlan_data" 20480 2116 ;; - re450) + re450|\ + tl-wr902ac-v1) ath10kcal_extract "art" 20480 2116 ath10kcal_patch_mac $(macaddr_add $(cat /sys/class/net/eth0/address) -2) ;; |