pistachio: remove kernel 4.9 support

Signed-off-by: Matti Laakso <matti.laakso@outlook.com>

1 files changed, 0 insertions, 47 deletions

diff --git a/target/linux/pistachio/patches-4.9/109-MIPS-DTS-img-marduk-switch-mmc-to-1-bit-mode.patch b/target/linux/pistachio/patches-4.9/109-MIPS-DTS-img-marduk-switch-mmc-to-1-bit-mode.patch
deleted file mode 100644
index 22fc42b..0000000
--- a/target/linux/pistachio/patches-4.9/109-MIPS-DTS-img-marduk-switch-mmc-to-1-bit-mode.patch
+++ /dev/null
@@ -1,47 +0,0 @@
-From 981c1d416af45eff207227aec106381ac23aac99 Mon Sep 17 00:00:00 2001
-From: Ian Pozella <Ian.Pozella@imgtec.com>
-Date: Mon, 20 Feb 2017 10:00:52 +0000
-Subject: MIPS: DTS: img: marduk: switch mmc to 1 bit mode
-
-The mmc block in Pistachio allows 1 to 8 data bits to be used.
-Marduk uses 4 bits allowing the upper 4 bits to be allocated
-to the Mikrobus ports. However these bits are still connected
-internally meaning the mmc block recieves signals on all data lines
-and seems the internal HW CRC checks get corrupted by this erroneous
-data.
-
-We cannot control what data is sent on these lines because they go
-to external ports. 1 bit mode does not exhibit the issue hence the
-safe default is to use this. If a user knows that in their use case
-they will not use the upper bits then they can set to 4 bit mode in
-order to improve performance.
-
-Also make sure that the upper 4 bits don't get allocated to the mmc
-driver (the default is to assign all 8 pins) so they can be allocated
-to other drivers. Allocating all 4 despite setting 1 bit mode as this
-matches what is there in hardware.
-
-Signed-off-by: Ian Pozella <Ian.Pozella@imgtec.com>
----
- arch/mips/boot/dts/img/pistachio_marduk.dts | 3 ++-
- 1 file changed, 2 insertions(+), 1 deletion(-)
-
---- a/arch/mips/boot/dts/img/pistachio_marduk.dts
-+++ b/arch/mips/boot/dts/img/pistachio_marduk.dts
-@@ -120,7 +120,7 @@
- 
- &sdhost {
- 	status = "okay";
--	bus-width = <4>;
-+	bus-width = <1>;
- 	disable-wp;
- };
- 
-@@ -130,6 +130,7 @@
- 
- &pin_sdhost_data {
- 	drive-strength = <2>;
-+	pins = "mfio17", "mfio18", "mfio19", "mfio20";
- };
- 
- &pwm {