ramips: Support for RAMIPS based Tripmate HT-TM02 board

Provides support for the Tripmate HT-TM02 personal router including LEDs and
reset button. “Mode” switch is not supported. New profile includes full set
of packages required to enable LEDs, USB, and LUCI. Patches were applied
against trunk snapshot r42649. Functionality has been tested in AP, basic wifi
client, wifi router, and routed client modes - all good.

Signed-off-by: Ron Curry <wingspinner@gmail.com>

SVN-Revision: 42785

8 files changed, 153 insertions, 0 deletions

diff --git a/target/linux/ramips/base-files/etc/board.d/01_leds b/target/linux/ramips/base-files/etc/board.d/01_leds
index bf646ed..ecaaaff 100755
--- a/target/linux/ramips/base-files/etc/board.d/01_leds
+++ b/target/linux/ramips/base-files/etc/board.d/01_leds
@@ -112,6 +112,10 @@ case $board in
 	hlk-rm04)
 		set_wifi_led "rt2800pci-phy0::radio"
 		;;
+        ht-tm02)
+		ucidef_set_led_netdev "eth" "ETH" "ht-tm02:white:status" "eth0"
+		set_wifi_led "ht-tm02:blue:wifi"
+                ;;
 	all0239-3g|\
 	hw550-3g)
 		set_usb_led "hw550-3g:green:usb"
diff --git a/target/linux/ramips/base-files/etc/board.d/02_network b/target/linux/ramips/base-files/etc/board.d/02_network
index e027b3b..c462fd8 100755
--- a/target/linux/ramips/base-files/etc/board.d/02_network
+++ b/target/linux/ramips/base-files/etc/board.d/02_network
@@ -97,6 +97,12 @@ ramips_setup_interfaces()
 		ucidef_add_switch_vlan "switch0" "2" "4 9t"
 		;;
 
+	ht-tm02)
+		ucidef_set_interface_lan "eth0.1"
+		ucidef_add_switch "switch0" "1" "1"
+		ucidef_add_switch_vlan "switch0" "1" "4 6t"
+		;;
+
 	3g-6200n | \
 	dir-610-a1 | \
 	dir-300-b7 | \
@@ -253,6 +259,7 @@ ramips_setup_macs()
 	hlk-rm04 | \
 	mpr-a1 | \
 	mpr-a2 | \
+        ht-tm02 | \
 	dir-300-b7 | \
 	dir-320-b1 | \
 	psr-680w |\
diff --git a/target/linux/ramips/base-files/etc/diag.sh b/target/linux/ramips/base-files/etc/diag.sh
index 9ad7ccb..9752eb2 100755
--- a/target/linux/ramips/base-files/etc/diag.sh
+++ b/target/linux/ramips/base-files/etc/diag.sh
@@ -63,6 +63,9 @@ get_status_led() {
 	hlk-rm04)
 		status_led="hlk-rm04:red:power"
 		;;
+	ht-tm02)
+		status_led="ht-tm02:white:status"
+		;;
 	all0239-3g|\
 	hw550-3g)
 		status_led="hw550-3g:green:status"
diff --git a/target/linux/ramips/base-files/lib/ramips.sh b/target/linux/ramips/base-files/lib/ramips.sh
index bb42ace..68ff509 100755
--- a/target/linux/ramips/base-files/lib/ramips.sh
+++ b/target/linux/ramips/base-files/lib/ramips.sh
@@ -157,6 +157,9 @@ ramips_board_detect() {
 	*"HILINK HLK-RM04")
 		name="hlk-rm04"
 		;;
+	*"HOOTOO HT-TM02")
+		name="ht-tm02"
+		;;
 	*"HAME MPR-A1")
  		name="mpr-a1"
  		;;
diff --git a/target/linux/ramips/base-files/lib/upgrade/platform.sh b/target/linux/ramips/base-files/lib/upgrade/platform.sh
index 407c218..4aec780 100755
--- a/target/linux/ramips/base-files/lib/upgrade/platform.sh
+++ b/target/linux/ramips/base-files/lib/upgrade/platform.sh
@@ -52,6 +52,7 @@ platform_check_image() {
 	hw550-3g | \
 	hg255d | \
 	hlk-rm04 | \
+	ht-tm02 | \
 	ip2202 | \
 	m3 | \
 	m4 | \
diff --git a/target/linux/ramips/dts/HT-TM02.dts b/target/linux/ramips/dts/HT-TM02.dts
new file mode 100644
index 0000000..1f456f0
--- /dev/null
+++ b/target/linux/ramips/dts/HT-TM02.dts
@@ -0,0 +1,104 @@
+/dts-v1/;
+
+/include/ "rt5350.dtsi"
+
+/ {
+	compatible = "HT-TM02", "ralink,rt5350-soc";
+	model = "HOOTOO HT-TM02";
+
+	palmbus@10000000 {
+
+               gpio0: gpio@600 {
+			status = "okay";
+               };
+               
+		spi@b00 {
+			status = "okay";
+			m25p80@0 {
+				#address-cells = <1>;
+				#size-cells = <1>;
+				compatible = "mx25l6405d";
+				reg = <0 0>;
+				linux,modalias = "m25p80", "mx25l6405d";
+				spi-max-frequency = <10000000>;
+
+				partition@0 {
+					label = "u-boot";
+					reg = <0x0 0x30000>;
+					read-only;
+				};
+
+				partition@30000 {
+					label = "u-boot-env";
+					reg = <0x30000 0x10000>;
+					read-only;
+				};
+
+				factory: partition@40000 {
+					label = "factory";
+					reg = <0x40000 0x10000>;
+					read-only;
+				};
+
+				partition@50000 {
+					label = "firmware";
+					reg = <0x50000 0x7b0000>;
+				};
+			};
+		};
+	};
+
+	pinctrl {
+		state_default: pinctrl0 {
+			gpio {
+				ralink,group = "i2c", "jtag", "uartf";
+				ralink,function = "gpio";
+			};
+		};
+	};
+
+	ethernet@10100000 {
+		mtd-mac-address = <&factory 0x4>;
+	};
+
+	esw@10110000 {
+		ralink,portmap = <0x3f>;
+	};
+
+	wmac@10180000 {
+		ralink,mtd-eeprom = <&factory 0>;
+	};
+
+	ehci@101c0000 {
+		status = "okay";
+	};
+
+	ohci@101c1000 {
+		status = "okay";
+	};
+
+	gpio-leds {
+		compatible = "gpio-leds";
+		wifi  {
+			label = "ht-tm02:blue:wifi";
+			gpios = <&gpio0 7 1>;
+		};
+		status  {
+			label = "ht-tm02:yellow:status";
+			gpios = <&gpio0 12 1>;
+		};
+
+	};
+
+	gpio-keys-polled {
+		compatible = "gpio-keys-polled";
+		#address-cells = <1>;
+		#size-cells = <0>;
+		poll-interval = <20>;
+		wps {
+			label = "reset";
+			gpios = <&gpio0 10 1>;
+			linux,code = <0x198>;
+		};
+	};
+};
diff --git a/target/linux/ramips/image/Makefile b/target/linux/ramips/image/Makefile
index 35057e4..c365d9d 100644
--- a/target/linux/ramips/image/Makefile
+++ b/target/linux/ramips/image/Makefile
@@ -434,6 +434,8 @@ define BuildFirmware/HLKRM04/initramfs
 endef
 Image/Build/Profile/HLKRM04=$(call BuildFirmware/HLKRM04/$(1),$(1),hlk-rm04,HLKRM04,HLK-RM02)
 
+Image/Build/Profile/HT-TM02=$(call BuildFirmware/Default8M/$(1),$(1),ht-tm02,HT-TM02)
+
 Image/Build/Profile/M3=$(call BuildFirmware/Poray4M/$(1),$(1),m3,M3)
 
 Image/Build/Profile/M4=$(call BuildFirmware/PorayDualSize/$(1),$(1),m4,M4)
@@ -598,6 +600,7 @@ define Image/Build/Profile/Default
 	$(call Image/Build/Profile/FREESTATION5,$(1))
 #	$(call Image/Build/Profile/HG255D,$(1))
 	$(call Image/Build/Profile/HLKRM04,$(1))
+	$(call Image/Build/Profile/HT-TM02,$(1))
 	$(call Image/Build/Profile/HW550-3G,$(1))
 	$(call Image/Build/Profile/IP2202,$(1))
 	$(call Image/Build/Profile/M3,$(1))
diff --git a/target/linux/ramips/rt305x/profiles/hootoo.mk b/target/linux/ramips/rt305x/profiles/hootoo.mk
new file mode 100644
index 0000000..976226d
--- /dev/null
+++ b/target/linux/ramips/rt305x/profiles/hootoo.mk
@@ -0,0 +1,28 @@
+#
+# Copyright (C) 2013 OpenWrt.org
+#
+# This is free software, licensed under the GNU General Public License v2.
+# See /LICENSE for more information.
+#
+
+
+define Profile/HT-TM02
+	NAME:=HOOTOO HT-TM02
+	PACKAGES:=\
+		wpad-mini \
+		kmod-ledtrig-netdev kmod-ledtrig-timer kmod-leds-gpio kmod-ledtrig-default-on \
+		kmod-usb-core kmod-usb-ohci kmod-usb2 kmod-usb-net usbutils \
+		kmod-scsi-core kmod-scsi-generic kmod-fs-ext4 \
+		kmod-usb-storage kmod-usb-storage-extras block-mount \
+		kmod-usb-serial kmod-usb-serial-ftdi kmod-gpio-button-hotplug \
+		kmod-nls-cp437 kmod-nls-iso8859-1 kmod-nls-utf8 luci luci-mod-admin-full \
+		kmod-app-samba luci-theme-openwrt luci-proto-relay relayd nano \
+		fstools 
+endef
+
+define Profile/HT-TM02/Description
+	Package set for HOOTOO HT-TM02 board
+endef
+
+$(eval $(call Profile,HT-TM02))
+