diff options
| -rw-r--r-- | docs/network.tex | 24 |
1 files changed, 11 insertions, 13 deletions
diff --git a/docs/network.tex b/docs/network.tex index e4efd8d..c14c4db 100644 --- a/docs/network.tex +++ b/docs/network.tex @@ -54,7 +54,7 @@ config interface "lan" option ifname "eth0" option proto "dhcp" option ipaddr "192.168.1.1" (optional) - option hostname "openwrt" (optional) + option hostname "openwrt" (optional) \end{Verbatim} PPP based protocols (\texttt{pppoe}, \texttt{pptp}, ...) accept these options: @@ -70,7 +70,6 @@ PPP based protocols (\texttt{pppoe}, \texttt{pptp}, ...) accept these options: ",<interval>" to the keepalive value \item{demand} \\ Use Dial on Demand (value specifies the maximum idle time. - \item{server: (pptp)} \\ The remote pptp server IP \end{itemize} @@ -84,7 +83,7 @@ config interface "lan" option proto "pppoe" option username "username" option password "openwrt" - option mtu 1492 (optional) + option mtu "1492" (optional) \end{Verbatim} \subsubsection{Setting up static routes} @@ -96,10 +95,10 @@ Simply add a config section like this: \begin{Verbatim} config route foo - option interface lan - option target 1.1.1.0 - option netmask 255.255.255.0 - option gateway 192.168.1.1 + option interface "lan" + option target "1.1.1.0" + option netmask "255.255.255.0" + option gateway "192.168.1.1" \end{Verbatim} The name for the route section is optional, the \texttt{interface}, \texttt{target} and @@ -166,9 +165,9 @@ file and change the settings accordingly : \begin{Verbatim} config 6tunnel option tnlifname 'sixbone' - option remoteip4 '1.0.0.1' - option localip4 '1.0.0.2' - option localip6 '2001::DEAD::BEEF::1' + option remoteip4 '1.0.0.1' + option localip4 '1.0.0.2' + option localip6 '2001::DEAD::BEEF::1' \end{Verbatim} \begin{itemize} @@ -185,7 +184,7 @@ config 6tunnel This address is given by the tunnel broker \end{itemize} -Using the same package you can also setup an IPv6 bridged connection : +Using the same package you can also setup an IPv6 bridged connection: \begin{Verbatim} config 6bridge @@ -197,7 +196,6 @@ and uses ebtables to filter anything that is not IPv6 on the bridge. This configuration is particularly useful if your router is not IPv6 ND proxy capable (see: http://www.rfc-archive.org/getrfc.php?rfc=4389). - IPv6 static addressing is also supported using a similar setup as IPv4 but with the \texttt{ip6} prefixing (when applicable). @@ -205,6 +203,6 @@ IPv4 but with the \texttt{ip6} prefixing (when applicable). config interface "lan" option ifname "eth0" option proto "static" - option ip6addr "fe80::200:ff:fe00:0/64" + option ip6addr "fe80::200:ff:fe00:0/64" option ip6gw "2001::DEAF:BEE:1" \end{Verbatim} |