diff options
Diffstat (limited to 'target/linux/brcm2708')
6 files changed, 15 insertions, 14 deletions
diff --git a/target/linux/brcm2708/patches-4.1/0001-Main-bcm2708-bcm2709-linux-port.patch b/target/linux/brcm2708/patches-4.1/0001-Main-bcm2708-bcm2709-linux-port.patch index 80ad8c3..79891f8 100644 --- a/target/linux/brcm2708/patches-4.1/0001-Main-bcm2708-bcm2709-linux-port.patch +++ b/target/linux/brcm2708/patches-4.1/0001-Main-bcm2708-bcm2709-linux-port.patch @@ -168,7 +168,7 @@ Signed-off-by: Noralf Trønnes <noralf@tronnes.org> config ARCH_MULTIPLATFORM bool "Allow multiple platforms to be selected" depends on MMU -@@ -823,6 +859,9 @@ config ARCH_VIRT +@@ -824,6 +860,9 @@ config ARCH_VIRT # Kconfigs may be included either alphabetically (according to the # plat- suffix) or along side the corresponding mach-* source. # @@ -6745,7 +6745,7 @@ Signed-off-by: Noralf Trønnes <noralf@tronnes.org> ENTRY(cpu_v6_dcache_clean_area) --- a/arch/arm/mm/proc-v7.S +++ b/arch/arm/mm/proc-v7.S -@@ -456,6 +456,7 @@ __v7_setup: +@@ -460,6 +460,7 @@ __v7_setup_cont: orr r0, r0, r6 @ set them THUMB( orr r0, r0, #1 << 30 ) @ Thumb exceptions ret lr @ return to head.S:__ret diff --git a/target/linux/brcm2708/patches-4.1/0033-config-Enable-CONFIG_MEMCG-but-leave-it-disabled-due.patch b/target/linux/brcm2708/patches-4.1/0033-config-Enable-CONFIG_MEMCG-but-leave-it-disabled-due.patch index 2a2f9b3..71d7491 100644 --- a/target/linux/brcm2708/patches-4.1/0033-config-Enable-CONFIG_MEMCG-but-leave-it-disabled-due.patch +++ b/target/linux/brcm2708/patches-4.1/0033-config-Enable-CONFIG_MEMCG-but-leave-it-disabled-due.patch @@ -11,7 +11,7 @@ Subject: [PATCH 033/171] config: Enable CONFIG_MEMCG, but leave it disabled --- a/kernel/cgroup.c +++ b/kernel/cgroup.c -@@ -5393,6 +5393,29 @@ static int __init cgroup_disable(char *s +@@ -5394,6 +5394,29 @@ static int __init cgroup_disable(char *s } __setup("cgroup_disable=", cgroup_disable); diff --git a/target/linux/brcm2708/patches-4.1/0099-spi-bcm2835-Support-pin-groups-other-than-7-11.patch b/target/linux/brcm2708/patches-4.1/0099-spi-bcm2835-Support-pin-groups-other-than-7-11.patch index f414d10..05da85c 100644 --- a/target/linux/brcm2708/patches-4.1/0099-spi-bcm2835-Support-pin-groups-other-than-7-11.patch +++ b/target/linux/brcm2708/patches-4.1/0099-spi-bcm2835-Support-pin-groups-other-than-7-11.patch @@ -19,7 +19,7 @@ Signed-off-by: Phil Elwell <phil@raspberrypi.org> --- a/drivers/spi/spi-bcm2835.c +++ b/drivers/spi/spi-bcm2835.c -@@ -359,6 +359,8 @@ static int bcm2835_spi_setup(struct spi_ +@@ -376,6 +376,8 @@ static int bcm2835_spi_setup(struct spi_ { int err; struct gpio_chip *chip; @@ -28,7 +28,7 @@ Signed-off-by: Phil Elwell <phil@raspberrypi.org> /* * sanity checking the native-chipselects */ -@@ -375,15 +377,42 @@ static int bcm2835_spi_setup(struct spi_ +@@ -392,15 +394,42 @@ static int bcm2835_spi_setup(struct spi_ "setup: only two native chip-selects are supported\n"); return -EINVAL; } diff --git a/target/linux/brcm2708/patches-4.1/0156-spi-bcm2835-enable-dma-modes-for-transfers-meeting-c.patch b/target/linux/brcm2708/patches-4.1/0156-spi-bcm2835-enable-dma-modes-for-transfers-meeting-c.patch index 3521f08..15205d1 100644 --- a/target/linux/brcm2708/patches-4.1/0156-spi-bcm2835-enable-dma-modes-for-transfers-meeting-c.patch +++ b/target/linux/brcm2708/patches-4.1/0156-spi-bcm2835-enable-dma-modes-for-transfers-meeting-c.patch @@ -375,7 +375,7 @@ Signed-off-by: Mark Brown <broonie@kernel.org> static int bcm2835_spi_transfer_one_poll(struct spi_master *master, struct spi_device *spi, struct spi_transfer *tfr, -@@ -301,12 +582,26 @@ static int bcm2835_spi_transfer_one(stru +@@ -299,6 +580,11 @@ static int bcm2835_spi_transfer_one(stru return bcm2835_spi_transfer_one_poll(master, spi, tfr, cs, xfer_time_us); @@ -387,6 +387,7 @@ Signed-off-by: Mark Brown <broonie@kernel.org> return bcm2835_spi_transfer_one_irq(master, spi, tfr, cs); } +@@ -324,6 +610,15 @@ static int bcm2835_spi_prepare_message(s static void bcm2835_spi_handle_err(struct spi_master *master, struct spi_message *msg) { @@ -402,7 +403,7 @@ Signed-off-by: Mark Brown <broonie@kernel.org> bcm2835_spi_reset_hw(master); } -@@ -505,6 +800,8 @@ static int bcm2835_spi_probe(struct plat +@@ -523,6 +818,8 @@ static int bcm2835_spi_probe(struct plat goto out_clk_disable; } @@ -411,7 +412,7 @@ Signed-off-by: Mark Brown <broonie@kernel.org> /* initialise the hardware with the default polarities */ bcm2835_wr(bs, BCM2835_SPI_CS, BCM2835_SPI_CS_CLEAR_RX | BCM2835_SPI_CS_CLEAR_TX); -@@ -535,6 +832,8 @@ static int bcm2835_spi_remove(struct pla +@@ -553,6 +850,8 @@ static int bcm2835_spi_remove(struct pla clk_disable_unprepare(bs->clk); diff --git a/target/linux/brcm2708/patches-4.1/0159-spi-bcm2835-fixed-compile-issues-due-to-embedded-com.patch b/target/linux/brcm2708/patches-4.1/0159-spi-bcm2835-fixed-compile-issues-due-to-embedded-com.patch index 6f5cee2..3941122 100644 --- a/target/linux/brcm2708/patches-4.1/0159-spi-bcm2835-fixed-compile-issues-due-to-embedded-com.patch +++ b/target/linux/brcm2708/patches-4.1/0159-spi-bcm2835-fixed-compile-issues-due-to-embedded-com.patch @@ -11,15 +11,15 @@ Signed-off-by: Martin Sperl <kernel@martin.sperl.org> --- a/drivers/spi/spi-bcm2835.c +++ b/drivers/spi/spi-bcm2835.c -@@ -592,6 +592,7 @@ static int bcm2835_spi_transfer_one(stru - return bcm2835_spi_transfer_one_irq(master, spi, tfr, cs); +@@ -609,6 +609,7 @@ static int bcm2835_spi_prepare_message(s + return 0; } +#if 0 static void bcm2835_spi_handle_err(struct spi_master *master, struct spi_message *msg) { -@@ -606,6 +607,7 @@ static void bcm2835_spi_handle_err(struc +@@ -623,6 +624,7 @@ static void bcm2835_spi_handle_err(struc /* and reset */ bcm2835_spi_reset_hw(master); } diff --git a/target/linux/brcm2708/patches-4.1/0163-spi-bcm2835-Fix-buld-error-from-previous-commit.patch b/target/linux/brcm2708/patches-4.1/0163-spi-bcm2835-Fix-buld-error-from-previous-commit.patch index 101f28e..21061de 100644 --- a/target/linux/brcm2708/patches-4.1/0163-spi-bcm2835-Fix-buld-error-from-previous-commit.patch +++ b/target/linux/brcm2708/patches-4.1/0163-spi-bcm2835-Fix-buld-error-from-previous-commit.patch @@ -9,15 +9,15 @@ Subject: [PATCH 163/171] spi: bcm2835: Fix buld error from previous commit --- a/drivers/spi/spi-bcm2835.c +++ b/drivers/spi/spi-bcm2835.c -@@ -592,7 +592,6 @@ static int bcm2835_spi_transfer_one(stru - return bcm2835_spi_transfer_one_irq(master, spi, tfr, cs); +@@ -609,7 +609,6 @@ static int bcm2835_spi_prepare_message(s + return 0; } -#if 0 static void bcm2835_spi_handle_err(struct spi_master *master, struct spi_message *msg) { -@@ -607,7 +606,6 @@ static void bcm2835_spi_handle_err(struc +@@ -624,7 +623,6 @@ static void bcm2835_spi_handle_err(struc /* and reset */ bcm2835_spi_reset_hw(master); } |