diff options
Diffstat (limited to 'target/linux/mvebu/patches-4.4')
3 files changed, 156 insertions, 0 deletions
diff --git a/target/linux/mvebu/patches-4.4/021-mtd-pxa3xx_nand-Increase-the-initial-chunk-size.patch b/target/linux/mvebu/patches-4.4/021-mtd-pxa3xx_nand-Increase-the-initial-chunk-size.patch new file mode 100644 index 0000000..f928f46 --- /dev/null +++ b/target/linux/mvebu/patches-4.4/021-mtd-pxa3xx_nand-Increase-the-initial-chunk-size.patch @@ -0,0 +1,42 @@ +From: =?UTF-8?q?Ezequiel=20Garc=C3=ADa?= <ezequiel@vanguardiasur.com.ar> +Date: Wed, 4 Nov 2015 13:13:41 -0300 +Subject: [PATCH] mtd: pxa3xx_nand: Increase the initial chunk size + +The chunk size represents the size of the data chunks, which +is used by the controllers that allow to split transfered data. + +However, the initial chunk size is used in a non-splitted way, +during device identification. Therefore, it must be large enough +for all the NAND commands issued during device identification. +This includes NAND_CMD_PARAM which was recently changed to +transfer up to 2048 bytes (for the redundant parameter pages). + +Thus, the initial chunk size should be 2048 as well. + +On Armada 370/XP platforms (NFCv2) booted without the keep-config +devicetree property, this commit fixes a timeout on the NAND_CMD_PARAM +command: + + [..] + pxa3xx-nand f10d0000.nand: This platform can't do DMA on this device + pxa3xx-nand f10d0000.nand: Wait time out!!! + nand: device found, Manufacturer ID: 0x2c, Chip ID: 0x38 + nand: Micron MT29F8G08ABABAWP + nand: 1024 MiB, SLC, erase size: 512 KiB, page size: 4096, OOB size: 224 + +Signed-off-by: Ezequiel Garcia <ezequiel@vanguardiasur.com.ar> +Acked-by: Robert Jarzmik <robert.jarzmik@free.fr> +Signed-off-by: Brian Norris <computersforpeace@gmail.com> +--- + +--- a/drivers/mtd/nand/pxa3xx_nand.c ++++ b/drivers/mtd/nand/pxa3xx_nand.c +@@ -1636,7 +1636,7 @@ static int pxa3xx_nand_scan(struct mtd_i + goto KEEP_CONFIG; + + /* Set a default chunk size */ +- info->chunk_size = 512; ++ info->chunk_size = PAGE_CHUNK_SIZE; + + ret = pxa3xx_nand_config_flash(info); + if (ret) diff --git a/target/linux/mvebu/patches-4.4/022-mtd-pxa3xx_nand-Fix-initial-controller-configuration.patch b/target/linux/mvebu/patches-4.4/022-mtd-pxa3xx_nand-Fix-initial-controller-configuration.patch new file mode 100644 index 0000000..260e7dc --- /dev/null +++ b/target/linux/mvebu/patches-4.4/022-mtd-pxa3xx_nand-Fix-initial-controller-configuration.patch @@ -0,0 +1,104 @@ +From: =?UTF-8?q?Ezequiel=20Garc=C3=ADa?= <ezequiel@vanguardiasur.com.ar> +Date: Wed, 4 Nov 2015 13:13:42 -0300 +Subject: [PATCH] mtd: pxa3xx_nand: Fix initial controller configuration + +The Data Flash Control Register (NDCR) contains two types +of parameters: those that are needed for device identification, +and those that can only be set after device identification. + +Therefore, the driver can't set them all at once and instead +needs to configure the first group before nand_scan_ident() +and the second group later. + +Let's split pxa3xx_nand_config in two halves, and set the +parameters that depend on the device geometry once this is known. + +Signed-off-by: Ezequiel Garcia <ezequiel@vanguardiasur.com.ar> +Signed-off-by: Brian Norris <computersforpeace@gmail.com> +--- + +--- a/drivers/mtd/nand/pxa3xx_nand.c ++++ b/drivers/mtd/nand/pxa3xx_nand.c +@@ -1419,34 +1419,43 @@ static int pxa3xx_nand_waitfunc(struct m + return NAND_STATUS_READY; + } + +-static int pxa3xx_nand_config_flash(struct pxa3xx_nand_info *info) ++static int pxa3xx_nand_config_ident(struct pxa3xx_nand_info *info) + { + struct platform_device *pdev = info->pdev; + struct pxa3xx_nand_platform_data *pdata = dev_get_platdata(&pdev->dev); +- struct pxa3xx_nand_host *host = info->host[info->cs]; +- struct mtd_info *mtd = host->mtd; +- struct nand_chip *chip = mtd->priv; + +- /* configure default flash values */ ++ /* Configure default flash values */ ++ info->chunk_size = PAGE_CHUNK_SIZE; + info->reg_ndcr = 0x0; /* enable all interrupts */ + info->reg_ndcr |= (pdata->enable_arbiter) ? NDCR_ND_ARB_EN : 0; + info->reg_ndcr |= NDCR_RD_ID_CNT(READ_ID_BYTES); +- info->reg_ndcr |= NDCR_SPARE_EN; /* enable spare by default */ ++ info->reg_ndcr |= NDCR_SPARE_EN; ++ ++ return 0; ++} ++ ++static void pxa3xx_nand_config_tail(struct pxa3xx_nand_info *info) ++{ ++ struct pxa3xx_nand_host *host = info->host[info->cs]; ++ struct mtd_info *mtd = host->mtd; ++ struct nand_chip *chip = mtd->priv; ++ + info->reg_ndcr |= (host->col_addr_cycles == 2) ? NDCR_RA_START : 0; + info->reg_ndcr |= (chip->page_shift == 6) ? NDCR_PG_PER_BLK : 0; + info->reg_ndcr |= (mtd->writesize == 2048) ? NDCR_PAGE_SZ : 0; +- +- return 0; + } + + static int pxa3xx_nand_detect_config(struct pxa3xx_nand_info *info) + { ++ struct platform_device *pdev = info->pdev; ++ struct pxa3xx_nand_platform_data *pdata = dev_get_platdata(&pdev->dev); + uint32_t ndcr = nand_readl(info, NDCR); + + /* Set an initial chunk size */ + info->chunk_size = ndcr & NDCR_PAGE_SZ ? 2048 : 512; + info->reg_ndcr = ndcr & + ~(NDCR_INT_MASK | NDCR_ND_ARB_EN | NFCV1_NDCR_ARB_CNTL); ++ info->reg_ndcr |= (pdata->enable_arbiter) ? NDCR_ND_ARB_EN : 0; + info->ndtr0cs0 = nand_readl(info, NDTR0CS0); + info->ndtr1cs0 = nand_readl(info, NDTR1CS0); + return 0; +@@ -1635,10 +1644,7 @@ static int pxa3xx_nand_scan(struct mtd_i + if (pdata->keep_config && !pxa3xx_nand_detect_config(info)) + goto KEEP_CONFIG; + +- /* Set a default chunk size */ +- info->chunk_size = PAGE_CHUNK_SIZE; +- +- ret = pxa3xx_nand_config_flash(info); ++ ret = pxa3xx_nand_config_ident(info); + if (ret) + return ret; + +@@ -1651,7 +1657,6 @@ static int pxa3xx_nand_scan(struct mtd_i + } + + KEEP_CONFIG: +- info->reg_ndcr |= (pdata->enable_arbiter) ? NDCR_ND_ARB_EN : 0; + if (info->reg_ndcr & NDCR_DWIDTH_M) + chip->options |= NAND_BUSWIDTH_16; + +@@ -1736,6 +1741,10 @@ KEEP_CONFIG: + host->row_addr_cycles = 3; + else + host->row_addr_cycles = 2; ++ ++ if (!pdata->keep_config) ++ pxa3xx_nand_config_tail(info); ++ + return nand_scan_tail(mtd); + } + diff --git a/target/linux/mvebu/patches-4.4/104-linksys_mamba_disable_keep_config.patch b/target/linux/mvebu/patches-4.4/104-linksys_mamba_disable_keep_config.patch new file mode 100644 index 0000000..4c6b311 --- /dev/null +++ b/target/linux/mvebu/patches-4.4/104-linksys_mamba_disable_keep_config.patch @@ -0,0 +1,10 @@ +--- a/arch/arm/boot/dts/armada-xp-linksys-mamba.dts ++++ b/arch/arm/boot/dts/armada-xp-linksys-mamba.dts +@@ -298,7 +298,6 @@ + nand@d0000 { + status = "okay"; + num-cs = <1>; +- marvell,nand-keep-config; + marvell,nand-enable-arbiter; + nand-on-flash-bbt; + nand-ecc-strength = <4>; |