diff options
Diffstat (limited to 'target/linux/ramips/patches-3.18')
5 files changed, 14 insertions, 14 deletions
diff --git a/target/linux/ramips/patches-3.18/0026-MIPS-ralink-add-mt7628an-support.patch b/target/linux/ramips/patches-3.18/0026-MIPS-ralink-add-mt7628an-support.patch index c622a12..c5c5d1a 100644 --- a/target/linux/ramips/patches-3.18/0026-MIPS-ralink-add-mt7628an-support.patch +++ b/target/linux/ramips/patches-3.18/0026-MIPS-ralink-add-mt7628an-support.patch @@ -264,7 +264,7 @@ Signed-off-by: John Crispin <blogic@openwrt.org> /* * When the CPU goes into sleep mode, the BUS clock will be too low for * USB to function properly -@@ -367,6 +500,52 @@ void __init ralink_of_remap(void) +@@ -367,6 +502,52 @@ void __init ralink_of_remap(void) panic("Failed to remap core resources"); } @@ -317,7 +317,7 @@ Signed-off-by: John Crispin <blogic@openwrt.org> void prom_soc_init(struct ralink_soc_info *soc_info) { void __iomem *sysc = (void __iomem *) KSEG1ADDR(MT7620_SYSC_BASE); -@@ -384,18 +563,25 @@ void prom_soc_init(struct ralink_soc_inf +@@ -384,18 +565,25 @@ void prom_soc_init(struct ralink_soc_inf rev = __raw_readl(sysc + SYSC_REG_CHIP_REV); bga = (rev >> CHIP_REV_PKG_SHIFT) & CHIP_REV_PKG_MASK; @@ -353,7 +353,7 @@ Signed-off-by: John Crispin <blogic@openwrt.org> } snprintf(soc_info->sys_type, RAMIPS_SYS_TYPE_LEN, -@@ -407,28 +593,11 @@ void prom_soc_init(struct ralink_soc_inf +@@ -407,28 +595,11 @@ void prom_soc_init(struct ralink_soc_inf cfg0 = __raw_readl(sysc + SYSC_REG_SYSTEM_CONFIG0); dram_type = (cfg0 >> SYSCFG0_DRAM_TYPE_SHIFT) & SYSCFG0_DRAM_TYPE_MASK; @@ -386,7 +386,7 @@ Signed-off-by: John Crispin <blogic@openwrt.org> pmu0 = __raw_readl(sysc + PMU0_CFG); pmu1 = __raw_readl(sysc + PMU1_CFG); -@@ -437,4 +606,9 @@ void prom_soc_init(struct ralink_soc_inf +@@ -437,4 +608,9 @@ void prom_soc_init(struct ralink_soc_inf (pmu0 & PMU_SW_SET) ? ("sw") : ("hw")); pr_info("Digital PMU set to %s control\n", (pmu1 & DIG_SW_SEL) ? ("sw") : ("hw")); diff --git a/target/linux/ramips/patches-3.18/0052-i2c-MIPS-adds-ralink-I2C-driver.patch b/target/linux/ramips/patches-3.18/0052-i2c-MIPS-adds-ralink-I2C-driver.patch index 9c25388..8ed0610 100644 --- a/target/linux/ramips/patches-3.18/0052-i2c-MIPS-adds-ralink-I2C-driver.patch +++ b/target/linux/ramips/patches-3.18/0052-i2c-MIPS-adds-ralink-I2C-driver.patch @@ -45,7 +45,7 @@ Signed-off-by: John Crispin <blogic@openwrt.org> +}; --- a/drivers/i2c/busses/Kconfig +++ b/drivers/i2c/busses/Kconfig -@@ -710,6 +710,10 @@ +@@ -710,6 +710,10 @@ config I2C_RK3X This driver can also be built as a module. If so, the module will be called i2c-rk3x. @@ -58,7 +58,7 @@ Signed-off-by: John Crispin <blogic@openwrt.org> help --- a/drivers/i2c/busses/Makefile +++ b/drivers/i2c/busses/Makefile -@@ -66,6 +66,7 @@ +@@ -66,6 +66,7 @@ obj-$(CONFIG_I2C_PNX) += i2c-pnx.o obj-$(CONFIG_I2C_PUV3) += i2c-puv3.o obj-$(CONFIG_I2C_PXA) += i2c-pxa.o obj-$(CONFIG_I2C_PXA_PCI) += i2c-pxa-pci.o diff --git a/target/linux/ramips/patches-3.18/0053-mmc-MIPS-ralink-add-sdhci-for-mt7620a-SoC.patch b/target/linux/ramips/patches-3.18/0053-mmc-MIPS-ralink-add-sdhci-for-mt7620a-SoC.patch index e8086b1..686c643 100644 --- a/target/linux/ramips/patches-3.18/0053-mmc-MIPS-ralink-add-sdhci-for-mt7620a-SoC.patch +++ b/target/linux/ramips/patches-3.18/0053-mmc-MIPS-ralink-add-sdhci-for-mt7620a-SoC.patch @@ -25,7 +25,7 @@ Signed-off-by: John Crispin <blogic@openwrt.org> --- a/drivers/mmc/host/Kconfig +++ b/drivers/mmc/host/Kconfig -@@ -773,3 +773,5 @@ +@@ -773,3 +773,5 @@ config MMC_SUNXI help This selects support for the SD/MMC Host Controller on Allwinner sunxi SoCs. diff --git a/target/linux/ramips/patches-3.18/0060-soc_type.patch b/target/linux/ramips/patches-3.18/0060-soc_type.patch index 60d3014..292a4ad 100644 --- a/target/linux/ramips/patches-3.18/0060-soc_type.patch +++ b/target/linux/ramips/patches-3.18/0060-soc_type.patch @@ -110,8 +110,8 @@ if (xtal_rate == MHZ(40)) cpu_rate = MHZ(580); else -@@ -418,7 +416,7 @@ void __init ralink_clk_init(void) - ralink_clk_add("10000c00.uartlite", periph_rate); +@@ -420,7 +418,7 @@ void __init ralink_clk_init(void) + ralink_clk_add("10000e00.uart2", periph_rate); ralink_clk_add("10180000.wmac", xtal_rate); - if (IS_ENABLED(CONFIG_USB) && mt762x_soc != MT762X_SOC_MT7628AN) { @@ -119,7 +119,7 @@ /* * When the CPU goes into sleep mode, the BUS clock will be too low for * USB to function properly -@@ -506,11 +504,11 @@ void prom_soc_init(struct ralink_soc_inf +@@ -508,11 +506,11 @@ void prom_soc_init(struct ralink_soc_inf if (n0 == MT7620_CHIP_NAME0 && n1 == MT7620_CHIP_NAME1) { if (bga) { @@ -133,7 +133,7 @@ name = "MT7620N"; soc_info->compatible = "ralink,mt7620n-soc"; #ifdef CONFIG_PCI -@@ -518,7 +516,7 @@ void prom_soc_init(struct ralink_soc_inf +@@ -520,7 +518,7 @@ void prom_soc_init(struct ralink_soc_inf #endif } } else if (n0 == MT7620_CHIP_NAME0 && n1 == MT7628_CHIP_NAME1) { @@ -142,7 +142,7 @@ name = "MT7628AN"; soc_info->compatible = "ralink,mt7628an-soc"; } else { -@@ -535,7 +533,7 @@ void prom_soc_init(struct ralink_soc_inf +@@ -537,7 +535,7 @@ void prom_soc_init(struct ralink_soc_inf dram_type = (cfg0 >> SYSCFG0_DRAM_TYPE_SHIFT) & SYSCFG0_DRAM_TYPE_MASK; soc_info->mem_base = MT7620_DRAM_BASE; @@ -151,7 +151,7 @@ mt7628_dram_init(soc_info); else mt7620_dram_init(soc_info); -@@ -548,7 +546,7 @@ void prom_soc_init(struct ralink_soc_inf +@@ -550,7 +548,7 @@ void prom_soc_init(struct ralink_soc_inf pr_info("Digital PMU set to %s control\n", (pmu1 & DIG_SW_SEL) ? ("sw") : ("hw")); diff --git a/target/linux/ramips/patches-3.18/999-non-pci-mt7620.patch b/target/linux/ramips/patches-3.18/999-non-pci-mt7620.patch index 815b1c7..ce56ae2 100644 --- a/target/linux/ramips/patches-3.18/999-non-pci-mt7620.patch +++ b/target/linux/ramips/patches-3.18/999-non-pci-mt7620.patch @@ -1,6 +1,6 @@ --- a/arch/mips/ralink/mt7620.c +++ b/arch/mips/ralink/mt7620.c -@@ -511,9 +511,6 @@ void prom_soc_init(struct ralink_soc_inf +@@ -513,9 +513,6 @@ void prom_soc_init(struct ralink_soc_inf ralink_soc = MT762X_SOC_MT7620N; name = "MT7620N"; soc_info->compatible = "ralink,mt7620n-soc"; |