summaryrefslogtreecommitdiff
path: root/target/linux
Commit message (Expand)AuthorAgeFilesLines
* omap: add kernel 4.4John Crispin2015-12-171-0/+721
* brcm2708: update 4.1 patchesJohn Crispin2015-12-17213-390/+1950
* cns3xxx: add GW2393 SupportJohn Crispin2015-12-171-1/+3
* cns3xxx: Fix commentJohn Crispin2015-12-171-1/+1
* lantiq: fix ARV7519RW22 buttonsJohn Crispin2015-12-171-7/+7
* lantiq: add the TDW8980 5GHz ledJohn Crispin2015-12-171-0/+7
* lantiq: Fix LED handling.John Crispin2015-12-171-24/+32
* lantiq: Configure LED polarity for TDW8970.John Crispin2015-12-171-0/+4
* lantiq: Configure disabled WLAN bands for TDW89X0.John Crispin2015-12-171-0/+1
* lantiq: Allow configuration of ath9k disabled bands and LED polarity from the...John Crispin2015-12-171-1/+17
* ath9k: Allow configuration of LED polarity in platform data.John Crispin2015-12-171-0/+1
* ramips: mt7621: fix error message when initramfs is too largeJohn Crispin2015-12-171-1/+1
* ramips: remove unwanted change from patchJohn Crispin2015-12-171-11/+0
* ramips: change CM_GCR_BASE_CMDEFTGT_MEM value to match datasheetJohn Crispin2015-12-171-0/+12
* ramips: mt7621: undo mips-cm probe hack to not wipe out memory regionsJohn Crispin2015-12-171-0/+20
* ramips: mt7621: setup memory region for pcie controller memoryJohn Crispin2015-12-171-0/+42
* ramips: mt7621: add patch to setup CM memory region for palmbusJohn Crispin2015-12-171-0/+36
* ralink: update config files to build the cleaned up ethernet driverJohn Crispin2015-12-177-28/+37
* ralink: drop dummy profile from mt7688John Crispin2015-12-172-14/+0
* ralink: fixup devicetree files to work with new ethernet driverJohn Crispin2015-12-17139-176/+190
* ralink: drop old ethernet driverJohn Crispin2015-12-1721-6842/+0
* ralink: add reworked ethernet driverJohn Crispin2015-12-1717-24/+7877
* bcm53xx: print bcm47xxpart buf to debug R8000 UBI problemRafał Miłecki2015-12-161-0/+40
* generic/4.4: bump to -rc5Imre Kaloz2015-12-155-39/+5
* ar71xx: clean up ethernet tx queue after reset, wake queues when done - fixes...Felix Fietkau2015-12-141-3/+8
* ar71xx: Update merakinand.sh to fix sysupgradeFelix Fietkau2015-12-131-1/+0
* ramips: add missing kernel symbolsJohn Crispin2015-12-126-0/+6
* ar71xx: add rx/tx delay definitons for qca955x's MACFelix Fietkau2015-12-121-0/+14
* ramips: add support for Ubiquiti EdgeRouter X (UBNT-ERX)John Crispin2015-12-127-2/+301
* ramips: add support for Spansion S34ML0[24]G2 flashJohn Crispin2015-12-121-0/+43
* ar71xx: add support for Cisco's MR18John Crispin2015-12-1216-0/+541
* ralink: remove stray "+" from ethernet driverJohn Crispin2015-12-121-1/+1
* ramips: move partition definitions out of mt7621.dtsi fileJohn Crispin2015-12-122-20/+22
* ramips: use gic timer as clocksource for mt7621John Crispin2015-12-123-0/+112
* ar71xx: reorganize target patches/files to make it possible to add boards wit...Felix Fietkau2015-12-1123-2314/+1843
* ar71xx: on wnr2200, revert the mac0/mac1, the ethernet interfaces are swapped...Felix Fietkau2015-12-111-3/+3
* Revert "ramips: use gic timer as clocksource for mt7621"Felix Fietkau2015-12-113-101/+0
* ar71xx: fix MAC address swapping on WNR2200 and fix the WLAN MAC addressFelix Fietkau2015-12-111-3/+4
* all: drop old uci-defaults.shJo-Philipp Wich2015-12-1138-38/+38
* brcm47xx: migrate network config to board detection frameworkJo-Philipp Wich2015-12-113-241/+173
* lantiq: get rid of ltq-vdsl-fwJohn Crispin2015-12-111-1/+0
* lantiq: fix led setup after switch to uci-defaults-new.shJohn Crispin2015-12-111-6/+7
* ar71xx: build image for TL-WR710N v2.1John Crispin2015-12-111-1/+10
* ar71xx: add LED driver NU801John Crispin2015-12-114-0/+476
* ar71xx: Add support for Wallys DR344John Crispin2015-12-119-0/+254
* ar71xx: image for AP121/16MJohn Crispin2015-12-111-1/+3
* ramips: add additional support for MQmaker WiTi boardJohn Crispin2015-12-117-1/+178
* ramips: Fix support for PBR-M1 boardJohn Crispin2015-12-113-22/+61
* ramips: use gic timer as clocksource for mt7621John Crispin2015-12-113-0/+101
* ramips: enable CPS for mt7621John Crispin2015-12-113-123/+21