summaryrefslogtreecommitdiff
path: root/target
Commit message (Expand)AuthorAgeFilesLines
* nuport-mac: delay call to napi_start() until fully able to process RXFlorian Fainelli2012-08-101-2/+2
* set a compatible command-line to boot from flashFlorian Fainelli2012-08-101-1/+1
* generic: rtl8366_smi: increase delay after switch hw resetGabor Juhos2012-08-101-3/+6
* Fix hard reset of alix/soekris hardware under heavy NIC loadJo-Philipp Wich2012-08-091-0/+60
* nuport-mac: use dma_mapping_error() instead of checking pointersFlorian Fainelli2012-08-091-2/+2
* nuport-mac: rework PHY interrupt configuration to avoid racesFlorian Fainelli2012-08-081-7/+7
* nuport-mac: close possible race condition during startFlorian Fainelli2012-08-081-1/+5
* nuport-mac: unmap the DMA buffer when closing deviceFlorian Fainelli2012-08-081-0/+4
* nuport-mac: check dma_map_single address return valuesFlorian Fainelli2012-08-081-0/+4
* build a Devolo dLAN USB Extender specific imageFlorian Fainelli2012-08-081-1/+8
* cleanup image generationFlorian Fainelli2012-08-081-4/+8
* pci gpio mappingJohn Crispin2012-08-081-4/+4
* bcm63xx: fix USB base registers and IRQs for BCM6328Jonas Gorski2012-08-0510-12/+100
* update tg3 driverHauke Mehrtens2012-08-051-75/+128
* generate image for Linksys e3200Hauke Mehrtens2012-08-051-0/+1
* brcm47xx: update gpio patchHauke Mehrtens2012-08-052-10/+8
* brcm47xx: fix patch which moves the flash struct in wgt634u codeHauke Mehrtens2012-08-052-12/+29
* W502V/ARV4525 wireless mac bugfixJohn Crispin2012-08-041-4/+1
* brcm47xx: use libgpio instaed of implementing the gpio interface ourself.Hauke Mehrtens2012-08-048-111/+712
* cleanup patchesJohn Crispin2012-08-03209-82080/+146978
* nuport-mac: properly protect the phy interrupt handlerFlorian Fainelli2012-08-021-2/+8
* Codel: avoid a nul rec_inv_sqrtJohn Crispin2012-08-021-0/+68
* fixes i2c clock enableJohn Crispin2012-08-021-0/+32
* ar71xx: simplify misc IRQ handlingGabor Juhos2012-08-021-0/+66
* ar71xx: fix AR934X_EHCI_SIZEGabor Juhos2012-08-024-4/+4
* ar71xx: image: stop the switch from the lzma-loader on the TL-WR1043NDGabor Juhos2012-08-022-0/+745
* ar71xx: image: allow to use board specific code in the lzma-loaderGabor Juhos2012-08-023-3/+10
* ar71xx: init switch hw_reset on the TL-WR1043ND boardGabor Juhos2012-08-021-2/+15
* generic: rtl836x: add hw_reset field to struct rtl8366_smiGabor Juhos2012-08-027-2/+35
* generic: rtl8366_smi: use __rtl8366_smi_cleanup instead of gpio_free callsGabor Juhos2012-08-021-2/+1
* add missing netmask to the network configFlorian Fainelli2012-08-011-0/+1
* assume the link is up and full-duplex by defaultFlorian Fainelli2012-08-011-2/+2
* add a default and suitable network config fileFlorian Fainelli2012-08-011-0/+12
* ar71xx: ew-dorin: added router firmware generationGabor Juhos2012-08-016-5/+49
* ar71xx: ew-dorin: added USB supportGabor Juhos2012-08-011-1/+3
* ar71xx: Buffalo WLAE-AG300N wireless led patchGabor Juhos2012-08-011-0/+4
* ar71xx: Buffalo WLAE-AG300N initial supportGabor Juhos2012-08-018-7/+156
* resync defconfig enable XZ compressionFlorian Fainelli2012-08-011-7/+1
* properly generate squashfs, jffs2 and initramfs images and kernelsFlorian Fainelli2012-07-312-16/+9
* disable crashlog on ARM platforms for the momentFlorian Fainelli2012-07-311-1/+1
* add lantiq svip supportJohn Crispin2012-07-3122-53/+17723
* bcm63xx: Add nb6 support (BCM6362 SoC base boards)Jonas Gorski2012-07-3110-6/+191
* bcm63xx: add basic bcm6362 supportJonas Gorski2012-07-3118-14/+1008
* bcm63xx: enable usb for bcm6328Jonas Gorski2012-07-311-0/+60
* bcm63xx: update enetswitch driverJonas Gorski2012-07-3131-44/+452
* bcm63xx: reorder patchesJonas Gorski2012-07-3113-17/+17
* move i2c module to target modules.mkFlorian Fainelli2012-07-291-0/+17
* resync configFlorian Fainelli2012-07-291-20/+0
* use the same description as other omap platforms (without the dash)Florian Fainelli2012-07-291-1/+1
* refresh pwm patchJohn Crispin2012-07-291-9/+5
generated by cgit v1.1 at 2024-12-16 07:19:55 +0000