From f683385e73f09c13fd08c3d352f3f1739c1944c4 Mon Sep 17 00:00:00 2001 From: Alex Maclean Date: Sun, 23 Jul 2017 20:06:44 +0100 Subject: ramips: add support for TP-Link RE350 The TP-Link RE350 is a wall-wart AC1200 range extender/access point with a single gigabit ethernet port and two non-detachable antennas, based on the MT7621A SoC with MT7603E and MT7612E radios. Firmware wise it is very similar to the QCA based RE450. SoC: MediaTek MT7621A (880MHz) Flash: 8MiB (Winbond W25Q64) RAM: 64MiB (DDR2) Ethernet: 1x 1Gbit Wireless: 2T2R 2.4Ghz (MT7603E) and 5GHz (MT7612E) LEDs: Power, 2.4G, 5G (blue), WPS (red and blue), ethernet link/act (green) Buttons: On/off, LED, reset, WPS Serial header at J1, 57600 8n1: Pin 1 TX Pin 2 RX Pin 3 GND Pin 4 3.3V Factory image can be uploaded directly through the stock UI. Signed-off-by: Alex Maclean --- target/linux/ramips/base-files/etc/board.d/02_network | 4 ++++ 1 file changed, 4 insertions(+) (limited to 'target/linux/ramips/base-files/etc/board.d/02_network') diff --git a/target/linux/ramips/base-files/etc/board.d/02_network b/target/linux/ramips/base-files/etc/board.d/02_network index d0f3fce..5cc7119 100755 --- a/target/linux/ramips/base-files/etc/board.d/02_network +++ b/target/linux/ramips/base-files/etc/board.d/02_network @@ -270,6 +270,10 @@ ramips_setup_interfaces() ucidef_add_switch "switch0" \ "1:lan:2" "2:lan:1" "4:wan" "6@eth0" ;; + re350-v1) + ucidef_add_switch "switch0" \ + "0:lan" "6@eth0" + ;; re6500) ucidef_add_switch "switch0" \ "0:lan:1" "1:lan:2" "2:lan:3" "3:lan:4" "6@eth0" -- cgit v1.1