From 6525bffc0a7ee6fabfe331a4d9e3eeabdd3516ae Mon Sep 17 00:00:00 2001 From: Giuseppe Lippolis Date: Sat, 10 Mar 2018 10:34:38 +0100 Subject: ramips: add support for DLINK DWR-921-C1 The DWR-921-C1 Wireless Routers with LTE embedded modem is based on the MT7620N SoC. Specification: * MediaTek MT7620N (580 Mhz) * 64 MB of RAM * 16 MB of FLASH * 802.11bgn radio * 5x 10/100 Mbps Ethernet (1 WAN and 4 LAN) * 2x external, detachable (LTE) antennas * UART header on PCB (57600 8n1) * 6x LED (GPIO-controlled) * 1x bi-color Signal Strength LED (GPIO-controlled) * 2x button * JBOOT bootloader The status led has been assigned to the dwr-921-c1:green:sigstrength (lte signal strength) led. At the end of the boot it is switched off and is available for lte operation. Work correctly also during sysupgrade operation. Installation: Apply factory image via d-link http web-gui. How to revert to OEM firmware: 1.) Push the reset button and turn on the power. Wait until LED start blinking (~10sec.) 2.) Upload original factory image via JBOOT http (IP: 192.168.123.254) 3.) If http doesn't work, it can be done with curl command: curl -F FN=@XXXXX.bin http://192.168.123.254/upg where XXXXX.bin is name of firmware file. Signed-off-by: Giuseppe Lippolis --- target/linux/ramips/base-files/etc/diag.sh | 3 +++ 1 file changed, 3 insertions(+) (limited to 'target/linux/ramips/base-files/etc/diag.sh') diff --git a/target/linux/ramips/base-files/etc/diag.sh b/target/linux/ramips/base-files/etc/diag.sh index d9f131b..7b90f6b 100644 --- a/target/linux/ramips/base-files/etc/diag.sh +++ b/target/linux/ramips/base-files/etc/diag.sh @@ -108,6 +108,9 @@ get_status_led() { zbt-wg2626) status_led="$boardname:green:status" ;; + dlink,dwr-921-c1) + status_led="$boardname:green:sigstrength" + ;; asl26555-8M|\ asl26555-16M) status_led="asl26555:green:power" -- cgit v1.1