From 9bc674f40f22596ef8c2ff6d7f9e53da0baa57e9 Mon Sep 17 00:00:00 2001 From: Andy Gross Date: Thu, 12 Jun 2014 14:34:10 -0500 Subject: [PATCH 133/182] spi: qup: Remove chip select function This patch removes the chip select function. Chip select should instead be supported using GPIOs, defining the DT entry "cs-gpios", and letting the SPI core assert/deassert the chip select as it sees fit. Signed-off-by: Andy Gross --- .../devicetree/bindings/spi/qcom,spi-qup.txt | 6 ++++ drivers/spi/spi-qup.c | 33 ++++---------------- 2 files changed, 12 insertions(+), 27 deletions(-) diff --git a/Documentation/devicetree/bindings/spi/qcom,spi-qup.txt b/Documentation/devicetree/bindings/spi/qcom,spi-qup.txt index b82a268..bee6ff2 100644 --- a/Documentation/devicetree/bindings/spi/qcom,spi-qup.txt +++ b/Documentation/devicetree/bindings/spi/qcom,spi-qup.txt @@ -23,6 +23,12 @@ Optional properties: - spi-max-frequency: Specifies maximum SPI clock frequency, Units - Hz. Definition as per Documentation/devicetree/bindings/spi/spi-bus.txt +- num-cs: total number of chipselects +- cs-gpios: should specify GPIOs used for chipselects. + The gpios will be referred to as reg = in the SPI child + nodes. If unspecified, a single SPI device without a chip + select can be used. + SPI slave nodes must be children of the SPI master node and can contain properties described in Documentation/devicetree/bindings/spi/spi-bus.txt diff --git a/drivers/spi/spi-qup.c b/drivers/spi/spi-qup.c index 65bf18e..dc128ac 100644 --- a/drivers/spi/spi-qup.c +++ b/drivers/spi/spi-qup.c @@ -424,31 +424,6 @@ static int spi_qup_io_config(struct spi_device *spi, struct spi_transfer *xfer) return 0; } -static void spi_qup_set_cs(struct spi_device *spi, bool enable) -{ - struct spi_qup *controller = spi_master_get_devdata(spi->master); - - u32 iocontol, mask; - - iocontol = readl_relaxed(controller->base + SPI_IO_CONTROL); - - /* Disable auto CS toggle and use manual */ - iocontol &= ~SPI_IO_C_MX_CS_MODE; - iocontol |= SPI_IO_C_FORCE_CS; - - iocontol &= ~SPI_IO_C_CS_SELECT_MASK; - iocontol |= SPI_IO_C_CS_SELECT(spi->chip_select); - - mask = SPI_IO_C_CS_N_POLARITY_0 << spi->chip_select; - - if (enable) - iocontol |= mask; - else - iocontol &= ~mask; - - writel_relaxed(iocontol, controller->base + SPI_IO_CONTROL); -} - static int spi_qup_transfer_one(struct spi_master *master, struct spi_device *spi, struct spi_transfer *xfer) @@ -571,12 +546,16 @@ static int spi_qup_probe(struct platform_device *pdev) return -ENOMEM; } + /* use num-cs unless not present or out of range */ + if (of_property_read_u16(dev->of_node, "num-cs", + &master->num_chipselect) || + (master->num_chipselect > SPI_NUM_CHIPSELECTS)) + master->num_chipselect = SPI_NUM_CHIPSELECTS; + master->bus_num = pdev->id; master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH | SPI_LOOP; - master->num_chipselect = SPI_NUM_CHIPSELECTS; master->bits_per_word_mask = SPI_BPW_RANGE_MASK(4, 32); master->max_speed_hz = max_freq; - master->set_cs = spi_qup_set_cs; master->transfer_one = spi_qup_transfer_one; master->dev.of_node = pdev->dev.of_node; master->auto_runtime_pm = true; -- 1.7.10.4