From: Russell King Date: Thu, 29 Dec 2016 11:03:09 +0000 Subject: [PATCH] net: phy: add 802.3 clause 45 support to phylib Add generic helpers for 802.3 clause 45 PHYs for >= 10Gbps support. Signed-off-by: Russell King --- create mode 100644 drivers/net/phy/phy-c45.c --- a/drivers/net/phy/Makefile +++ b/drivers/net/phy/Makefile @@ -1,7 +1,7 @@ # Makefile for Linux PHY drivers and MDIO bus drivers libphy-y := phy.o phy_device.o mdio_bus.o mdio_device.o \ - phy-core.o + phy-c45.o phy-core.o libphy-$(CONFIG_SWPHY) += swphy.o obj-$(CONFIG_MDIO_BOARDINFO) += mdio-boardinfo.o --- /dev/null +++ b/drivers/net/phy/phy-c45.c @@ -0,0 +1,234 @@ +/* + * Clause 45 PHY support + */ +#include +#include +#include +#include +#include + +/** + * genphy_c45_setup_forced - configures a forced speed + * @phydev: target phy_device struct + */ +int genphy_c45_pma_setup_forced(struct phy_device *phydev) +{ + int ctrl1, ctrl2, ret; + + /* Half duplex is not supported */ + if (phydev->duplex != DUPLEX_FULL) + return -EINVAL; + + ctrl1 = phy_read_mmd(phydev, MDIO_MMD_PMAPMD, MDIO_CTRL1); + if (ctrl1 < 0) + return ctrl1; + + ctrl2 = phy_read_mmd(phydev, MDIO_MMD_PMAPMD, MDIO_CTRL2); + if (ctrl2 < 0) + return ctrl2; + + ctrl1 &= ~MDIO_CTRL1_SPEEDSEL; + /* PMA/PMD type selection is 1.7.5:0 not 1.7.3:0. See 45.2.1.6.1. */ + ctrl2 &= ~(MDIO_PMA_CTRL2_TYPE | 0x30); + + switch (phydev->speed) { + case SPEED_10: + ctrl2 |= MDIO_PMA_CTRL2_10BT; + break; + case SPEED_100: + ctrl1 |= MDIO_PMA_CTRL1_SPEED100; + ctrl2 |= MDIO_PMA_CTRL2_100BTX; + break; + case SPEED_1000: + ctrl1 |= MDIO_PMA_CTRL1_SPEED1000; + /* Assume 1000base-T */ + ctrl2 |= MDIO_PMA_CTRL2_1000BT; + break; + case SPEED_10000: + ctrl1 |= MDIO_CTRL1_SPEED10G; + /* Assume 10Gbase-T */ + ctrl2 |= MDIO_PMA_CTRL2_10GBT; + break; + default: + return -EINVAL; + } + + ret = phy_write_mmd(phydev, MDIO_MMD_PMAPMD, MDIO_CTRL1, ctrl1); + if (ret < 0) + return ret; + + return phy_write_mmd(phydev, MDIO_MMD_PMAPMD, MDIO_CTRL2, ctrl2); +} +EXPORT_SYMBOL_GPL(genphy_c45_pma_setup_forced); + +/** + * genphy_c45_an_disable_aneg - disable auto-negotiation + * @phydev: target phy_device struct + * + * Disable auto-negotiation in the Clause 45 PHY. The link parameters + * parameters are controlled through the PMA/PMD MMD registers. + * + * Returns zero on success, negative errno code on failure. + */ +int genphy_c45_an_disable_aneg(struct phy_device *phydev) +{ + int val; + + val = phy_read_mmd(phydev, MDIO_MMD_AN, MDIO_CTRL1); + if (val < 0) + return val; + + val &= ~(MDIO_AN_CTRL1_ENABLE | MDIO_AN_CTRL1_RESTART); + + return phy_write_mmd(phydev, MDIO_MMD_AN, MDIO_CTRL1, val); +} +EXPORT_SYMBOL_GPL(genphy_c45_an_disable_aneg); + +/** + * genphy_c45_restart_aneg - Enable and restart auto-negotiation + * @phydev: target phy_device struct + * + * This assumes that the auto-negotiation MMD is present. + * + * Enable and restart auto-negotiation. + */ +int genphy_c45_restart_aneg(struct phy_device *phydev) +{ + int val; + + val = phy_read_mmd(phydev, MDIO_MMD_AN, MDIO_CTRL1); + if (val < 0) + return val; + + val |= MDIO_AN_CTRL1_ENABLE | MDIO_AN_CTRL1_RESTART; + + return phy_write_mmd(phydev, MDIO_MMD_AN, MDIO_CTRL1, val); +} +EXPORT_SYMBOL_GPL(genphy_c45_restart_aneg); + +/** + * genphy_c45_aneg_done - return auto-negotiation complete status + * @phydev: target phy_device struct + * + * This assumes that the auto-negotiation MMD is present. + * + * Reads the status register from the auto-negotiation MMD, returning: + * - positive if auto-negotiation is complete + * - negative errno code on error + * - zero otherwise + */ +int genphy_c45_aneg_done(struct phy_device *phydev) +{ + int val = phy_read_mmd(phydev, MDIO_MMD_AN, MDIO_STAT1); + + return val < 0 ? val : val & MDIO_AN_STAT1_COMPLETE ? 1 : 0; +} +EXPORT_SYMBOL_GPL(genphy_c45_aneg_done); + +/** + * genphy_c45_read_link - read the overall link status from the MMDs + * @phydev: target phy_device struct + * @mmd_mask: MMDs to read status from + * + * Read the link status from the specified MMDs, and if they all indicate + * that the link is up, return positive. If an error is encountered, + * a negative errno will be returned, otherwise zero. + */ +int genphy_c45_read_link(struct phy_device *phydev, u32 mmd_mask) +{ + int val, devad; + bool link = true; + + while (mmd_mask) { + devad = __ffs(mmd_mask); + mmd_mask &= ~BIT(devad); + + val = phy_read_mmd(phydev, devad, MDIO_STAT1); + if (val < 0) + return val; + + /* Read twice because link state is latched and a + * read moves the current state into the register + */ + val = phy_read_mmd(phydev, devad, MDIO_STAT1); + if (val < 0) + return val; + + if (!(val & MDIO_STAT1_LSTATUS)) + link = false; + } + + return link; +} +EXPORT_SYMBOL_GPL(genphy_c45_read_link); + +/** + * genphy_c45_read_lpa - read the link partner advertisment and pause + * @phydev: target phy_device struct + * + * Read the Clause 45 defined base (7.19) and 10G (7.33) status registers, + * filling in the link partner advertisment, pause and asym_pause members + * in @phydev. This assumes that the auto-negotiation MMD is present, and + * the backplane bit (7.48.0) is clear. Clause 45 PHY drivers are expected + * to fill in the remainder of the link partner advert from vendor registers. + */ +int genphy_c45_read_lpa(struct phy_device *phydev) +{ + int val; + + /* Read the link partner's base page advertisment */ + val = phy_read_mmd(phydev, MDIO_MMD_AN, MDIO_AN_LPA); + if (val < 0) + return val; + + phydev->lp_advertising = mii_lpa_to_ethtool_lpa_t(val); + phydev->pause = val & LPA_PAUSE_CAP ? 1 : 0; + phydev->asym_pause = val & LPA_PAUSE_ASYM ? 1 : 0; + + /* Read the link partner's 10G advertisment */ + val = phy_read_mmd(phydev, MDIO_MMD_AN, MDIO_AN_10GBT_STAT); + if (val < 0) + return val; + + if (val & MDIO_AN_10GBT_STAT_LP10G) + phydev->lp_advertising |= ADVERTISED_10000baseT_Full; + + return 0; +} +EXPORT_SYMBOL_GPL(genphy_c45_read_lpa); + +/** + * genphy_c45_read_pma - read link speed etc from PMA + * @phydev: target phy_device struct + */ +int genphy_c45_read_pma(struct phy_device *phydev) +{ + int val; + + val = phy_read_mmd(phydev, MDIO_MMD_PMAPMD, MDIO_CTRL1); + if (val < 0) + return val; + + switch (val & MDIO_CTRL1_SPEEDSEL) { + case 0: + phydev->speed = SPEED_10; + break; + case MDIO_PMA_CTRL1_SPEED100: + phydev->speed = SPEED_100; + break; + case MDIO_PMA_CTRL1_SPEED1000: + phydev->speed = SPEED_1000; + break; + case MDIO_CTRL1_SPEED10G: + phydev->speed = SPEED_10000; + break; + default: + phydev->speed = SPEED_UNKNOWN; + break; + } + + phydev->duplex = DUPLEX_FULL; + + return 0; +} +EXPORT_SYMBOL_GPL(genphy_c45_read_pma); --- a/drivers/net/phy/phy_device.c +++ b/drivers/net/phy/phy_device.c @@ -1410,27 +1410,19 @@ EXPORT_SYMBOL(genphy_read_status); static int gen10g_read_status(struct phy_device *phydev) { - int devad, reg; u32 mmd_mask = phydev->c45_ids.devices_in_package; - - phydev->link = 1; + int ret; /* For now just lie and say it's 10G all the time */ phydev->speed = SPEED_10000; phydev->duplex = DUPLEX_FULL; - for (devad = 0; mmd_mask; devad++, mmd_mask = mmd_mask >> 1) { - if (!(mmd_mask & 1)) - continue; - - /* Read twice because link state is latched and a - * read moves the current state into the register - */ - phy_read_mmd(phydev, devad, MDIO_STAT1); - reg = phy_read_mmd(phydev, devad, MDIO_STAT1); - if (reg < 0 || !(reg & MDIO_STAT1_LSTATUS)) - phydev->link = 0; - } + /* Avoid reading the vendor MMDs */ + mmd_mask &= ~(BIT(MDIO_MMD_VEND1) | BIT(MDIO_MMD_VEND2)); + + ret = genphy_c45_read_link(phydev, mmd_mask); + + phydev->link = ret > 0 ? 1 : 0; return 0; } --- a/include/linux/phy.h +++ b/include/linux/phy.h @@ -807,6 +807,8 @@ static inline const char *phydev_name(co void phy_attached_print(struct phy_device *phydev, const char *fmt, ...) __printf(2, 3); void phy_attached_info(struct phy_device *phydev); + +/* Clause 22 PHY */ int genphy_config_init(struct phy_device *phydev); int genphy_setup_forced(struct phy_device *phydev); int genphy_restart_aneg(struct phy_device *phydev); @@ -817,6 +819,16 @@ int genphy_read_status(struct phy_device int genphy_suspend(struct phy_device *phydev); int genphy_resume(struct phy_device *phydev); int genphy_soft_reset(struct phy_device *phydev); + +/* Clause 45 PHY */ +int genphy_c45_restart_aneg(struct phy_device *phydev); +int genphy_c45_aneg_done(struct phy_device *phydev); +int genphy_c45_read_link(struct phy_device *phydev, u32 mmd_mask); +int genphy_c45_read_lpa(struct phy_device *phydev); +int genphy_c45_read_pma(struct phy_device *phydev); +int genphy_c45_pma_setup_forced(struct phy_device *phydev); +int genphy_c45_an_disable_aneg(struct phy_device *phydev); + void phy_driver_unregister(struct phy_driver *drv); void phy_drivers_unregister(struct phy_driver *drv, int n); int phy_driver_register(struct phy_driver *new_driver, struct module *owner);