blob: 46657940b8b5e60cb8d74f99cff8acf21806386c (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
|
From 3a7853f0dd24e81dc920c98a5c7e8cfdde81bb45 Mon Sep 17 00:00:00 2001
From: Gabor Juhos <juhosg@openwrt.org>
Date: Thu, 16 Jan 2014 16:58:58 +0100
Subject: [PATCH] spi-ath79: fix initial GPIO CS line setup
The 'ath79_spi_setup_cs' function initializes the chip
select line of a given SPI device in order to make sure
that the device is inactive.
If the SPI_CS_HIGH bit is set for a given device, it
means that the CS line of that device is active HIGH
so it must be set to LOW initially. In case of GPIO
CS lines, the 'ath79_spi_setup_cs' function does the
opposite of that due to the wrong GPIO flags.
Fix the code to use the correct GPIO flags.
Reported-by: Ronald Wahl <ronald.wahl@raritan.com>
Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
---
drivers/spi/spi-ath79.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
--- a/drivers/spi/spi-ath79.c
+++ b/drivers/spi/spi-ath79.c
@@ -132,9 +132,9 @@ static int ath79_spi_setup_cs(struct spi
flags = GPIOF_DIR_OUT;
if (spi->mode & SPI_CS_HIGH)
- flags |= GPIOF_INIT_HIGH;
- else
flags |= GPIOF_INIT_LOW;
+ else
+ flags |= GPIOF_INIT_HIGH;
status = gpio_request_one(cdata->gpio, flags,
dev_name(&spi->dev));
|
