1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
|
--- a/arch/mips/ath79/mach-db120.c
+++ b/arch/mips/ath79/mach-db120.c
@@ -2,7 +2,7 @@
* Atheros DB120 reference board support
*
* Copyright (c) 2011 Qualcomm Atheros
- * Copyright (c) 2011 Gabor Juhos <juhosg@openwrt.org>
+ * Copyright (c) 2011-2012 Gabor Juhos <juhosg@openwrt.org>
*
* All rights reserved.
*
@@ -38,16 +38,25 @@
*/
#include <linux/pci.h>
+#include <linux/phy.h>
+#include <linux/platform_device.h>
#include <linux/ath9k_platform.h>
+#include <linux/ar8216_platform.h>
-#include "machtypes.h"
+#include <asm/mach-ath79/ar71xx_regs.h>
+
+#include "common.h"
+#include "dev-ap9x-pci.h"
+#include "dev-eth.h"
#include "dev-gpio-buttons.h"
#include "dev-leds-gpio.h"
+#include "dev-m25p80.h"
#include "dev-spi.h"
#include "dev-usb.h"
#include "dev-wmac.h"
-#include "pci.h"
+#include "machtypes.h"
+#define DB120_GPIO_LED_USB 11
#define DB120_GPIO_LED_WLAN_5G 12
#define DB120_GPIO_LED_WLAN_2G 13
#define DB120_GPIO_LED_STATUS 14
@@ -58,8 +67,10 @@
#define DB120_KEYS_POLL_INTERVAL 20 /* msecs */
#define DB120_KEYS_DEBOUNCE_INTERVAL (3 * DB120_KEYS_POLL_INTERVAL)
-#define DB120_WMAC_CALDATA_OFFSET 0x1000
-#define DB120_PCIE_CALDATA_OFFSET 0x5000
+#define DB120_MAC0_OFFSET 0
+#define DB120_MAC1_OFFSET 6
+#define DB120_WMAC_CALDATA_OFFSET 0x1000
+#define DB120_PCIE_CALDATA_OFFSET 0x5000
static struct gpio_led db120_leds_gpio[] __initdata = {
{
@@ -82,6 +93,11 @@ static struct gpio_led db120_leds_gpio[]
.gpio = DB120_GPIO_LED_WLAN_2G,
.active_low = 1,
},
+ {
+ .name = "db120:green:usb",
+ .gpio = DB120_GPIO_LED_USB,
+ .active_low = 1,
+ }
};
static struct gpio_keys_button db120_gpio_keys[] __initdata = {
@@ -95,66 +111,89 @@ static struct gpio_keys_button db120_gpi
},
};
-static struct ath79_spi_controller_data db120_spi0_data = {
- .cs_type = ATH79_SPI_CS_TYPE_INTERNAL,
- .cs_line = 0,
+static struct ar8327_pad_cfg db120_ar8327_pad0_cfg = {
+ .mode = AR8327_PAD_MAC_RGMII,
+ .txclk_delay_en = true,
+ .rxclk_delay_en = true,
+ .txclk_delay_sel = AR8327_CLK_DELAY_SEL1,
+ .rxclk_delay_sel = AR8327_CLK_DELAY_SEL2,
};
-static struct spi_board_info db120_spi_info[] = {
- {
- .bus_num = 0,
- .chip_select = 0,
- .max_speed_hz = 25000000,
- .modalias = "s25sl064a",
- .controller_data = &db120_spi0_data,
+static struct ar8327_platform_data db120_ar8327_data = {
+ .pad0_cfg = &db120_ar8327_pad0_cfg,
+ .cpuport_cfg = {
+ .force_link = 1,
+ .speed = AR8327_PORT_SPEED_1000,
+ .duplex = 1,
+ .txpause = 1,
+ .rxpause = 1,
}
};
-static struct ath79_spi_platform_data db120_spi_data = {
- .bus_num = 0,
- .num_chipselect = 1,
+static struct mdio_board_info db120_mdio0_info[] = {
+ {
+ .bus_id = "ag71xx-mdio.0",
+ .phy_addr = 0,
+ .platform_data = &db120_ar8327_data,
+ },
};
-#ifdef CONFIG_PCI
-static struct ath9k_platform_data db120_ath9k_data;
-
-static int db120_pci_plat_dev_init(struct pci_dev *dev)
+static void __init db120_gmac_setup(void)
{
- switch (PCI_SLOT(dev->devfn)) {
- case 0:
- dev->dev.platform_data = &db120_ath9k_data;
- break;
- }
+ void __iomem *base;
+ u32 t;
- return 0;
-}
+ base = ioremap(AR934X_GMAC_BASE, AR934X_GMAC_SIZE);
-static void __init db120_pci_init(u8 *eeprom)
-{
- memcpy(db120_ath9k_data.eeprom_data, eeprom,
- sizeof(db120_ath9k_data.eeprom_data));
+ t = __raw_readl(base + AR934X_GMAC_REG_ETH_CFG);
+ t &= ~(AR934X_ETH_CFG_RGMII_GMAC0 | AR934X_ETH_CFG_MII_GMAC0 |
+ AR934X_ETH_CFG_MII_GMAC0 | AR934X_ETH_CFG_SW_ONLY_MODE);
+ t |= AR934X_ETH_CFG_RGMII_GMAC0 | AR934X_ETH_CFG_SW_ONLY_MODE;
+
+ __raw_writel(t, base + AR934X_GMAC_REG_ETH_CFG);
- ath79_pci_set_plat_dev_init(db120_pci_plat_dev_init);
- ath79_register_pci();
+ iounmap(base);
}
-#else
-static inline void db120_pci_init(void) {}
-#endif /* CONFIG_PCI */
static void __init db120_setup(void)
{
u8 *art = (u8 *) KSEG1ADDR(0x1fff0000);
+ ath79_gpio_output_select(DB120_GPIO_LED_USB, AR934X_GPIO_OUT_GPIO);
+ ath79_register_m25p80(NULL);
+
ath79_register_leds_gpio(-1, ARRAY_SIZE(db120_leds_gpio),
db120_leds_gpio);
ath79_register_gpio_keys_polled(-1, DB120_KEYS_POLL_INTERVAL,
ARRAY_SIZE(db120_gpio_keys),
db120_gpio_keys);
- ath79_register_spi(&db120_spi_data, db120_spi_info,
- ARRAY_SIZE(db120_spi_info));
ath79_register_usb();
ath79_register_wmac(art + DB120_WMAC_CALDATA_OFFSET, NULL);
- db120_pci_init(art + DB120_PCIE_CALDATA_OFFSET);
+ ap91_pci_init(art + DB120_PCIE_CALDATA_OFFSET, NULL);
+
+ db120_gmac_setup();
+
+ ath79_register_mdio(1, 0x0);
+ ath79_register_mdio(0, 0x0);
+
+ ath79_init_mac(ath79_eth0_data.mac_addr, art + DB120_MAC0_OFFSET, 0);
+
+ mdiobus_register_board_info(db120_mdio0_info,
+ ARRAY_SIZE(db120_mdio0_info));
+
+ /* GMAC0 is connected to an AR8327 switch */
+ ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII;
+ ath79_eth0_data.phy_mask = BIT(0);
+ ath79_eth0_data.mii_bus_dev = &ath79_mdio0_device.dev;
+ ath79_register_eth(0);
+
+ /* GMAC1 is connected to the internal switch */
+ ath79_init_mac(ath79_eth1_data.mac_addr, art + DB120_MAC1_OFFSET, 0);
+ ath79_eth1_data.phy_if_mode = PHY_INTERFACE_MODE_GMII;
+ ath79_eth1_data.speed = SPEED_1000;
+ ath79_eth1_data.duplex = DUPLEX_FULL;
+
+ ath79_register_eth(1);
}
MIPS_MACHINE(ATH79_MACH_DB120, "DB120", "Atheros DB120 reference board",
--- a/arch/mips/ath79/Kconfig
+++ b/arch/mips/ath79/Kconfig
@@ -31,9 +31,11 @@ config ATH79_MACH_AP81
config ATH79_MACH_DB120
bool "Atheros DB120 reference board"
select SOC_AR934X
+ select ATH79_DEV_AP9X_PCI if PCI
+ select ATH79_DEV_ETH
select ATH79_DEV_GPIO_BUTTONS
select ATH79_DEV_LEDS_GPIO
- select ATH79_DEV_SPI
+ select ATH79_DEV_M25P80
select ATH79_DEV_USB
select ATH79_DEV_WMAC
help
|
